Drehzahlsimulation mit Stimboard Hall/VR

Antworten
OW
Beiträge: 65
Registriert: So Feb 18, 2007 11:08 am
Wohnort: Ulm

Drehzahlsimulation mit Stimboard Hall/VR

Beitrag von OW »

Hallo,
ich verwende ein V3 Board mit einem Stim V2.2. Ursprünglich hatte ich vor einen Hallsensor als Drehzahlgeber zu verwenden, nun möchte ich allerdings doche einen VR Sensor nehme, da dieser bereits am Motorrad vorhanden ist.

Als ich das Board auf Hallsensor gelötet hatte funktionierte meine Drehzahlanzeige problemlos in Megatune.Nun habe ich zusätzlich die Bauteile für den VR Circuit installiert, leider bekomme ich damit mit dem Stim kein Drehzahlsignal in Megatune.

Ist es überhaupt möglich mit dem Stimboard ein VR Signal zu generieren? Da ich Stimseitig ja nichts geändert habe, liefert dieses mir ja nach wie vor ein Rechtecksignal, oder vergesse ich da was zu berücksichtigen?

Danke für eure Tipps!
MSII V3.0 Board, Yamaha R6 Drosselklappen, LC-1 Sonde, Code 2.83
OW
Beiträge: 65
Registriert: So Feb 18, 2007 11:08 am
Wohnort: Ulm

Re: Drehzahlsimulation mit Stimboard Hall/VR

Beitrag von OW »

Habe m Assembly Guide (V3) dazu folgendes gefunden:

First, look at the RPM - it should change when you move the RPM pots on the stimulator. Note that if you have installed the VR input circuit jumpers in step #52, the stim is not currently designed to put out the sort of signal (AC) the VR circuit expects. However, by adjusting the pots at R52 and R56, you might be able to get a useable signal into MegaSquirt. The RPM may not be stable at each end of 1000-6500 range, but it should be workable over that range, at least. Then you'll know that the rpm input circuit is functioning at it should.
MSII V3.0 Board, Yamaha R6 Drosselklappen, LC-1 Sonde, Code 2.83
MK
Beiträge: 608
Registriert: Sa Mär 10, 2007 6:44 pm
Wohnort: Wolfenbüttel
Kontaktdaten:

Re: Drehzahlsimulation mit Stimboard Hall/VR

Beitrag von MK »

Also ich habe ein MiniMS (= v2.2 Board) und ebenfalls einen VR sensor.
Allerdings nutze ich am Moped den REVD1 Adapter von Zeeltronic:
http://www.zeeltronic.com/page/m_elec.php

Der setzt das Signal von Primärseite Zündspule in ein 12V Puls-Signal um, das mein MiniMS prima versteht.

Das Stim erzeugt anscheinend dasselbe, weil das tut ohne das ich was ändern musste (hab's aber auch assembled bekommen)
Ciao
Martin
----------------
RD350YPVS, Microsquirt, AlphaN
Antworten