Pickup signal problems,

Link zur MegaSquirt'nSpark Homepage
Antworten
KCPpieter
Beiträge: 17
Registriert: Do Aug 27, 2015 8:55 am

Pickup signal problems,

Beitrag von KCPpieter »

Hi,

i have a saab 9-5 with original pickup sensor and wheel on the crank.
its a 60-2 pickup.

but i am getting a strange signal, so the engine wont rev past 2000 and losses sync.
rpm go's from 2400 - 0 and back.

attacht scoop image.

i think the wheel in the engine is not good. but that almost impossible the original injection system did run. but not possible to build it back, car is complete empty. the have rebuild the engine couple years back.

change ecu, changed wirring from sensor, changed senor with other car. everything looks good. but the signal isn't good.
i have another car with original injection system Peak to peak is 5 -10 volt idle. this is only 3volt.
another car with same sensor that i have here is 20volt peak to peak idle and 70volts at redline.
Dateianhänge
9-5racer.png
9-5racer.png (26.33 KiB) 8027 mal betrachtet
9-5racer2.png
9-5racer2.png (79.16 KiB) 8029 mal betrachtet
Benutzeravatar
Alfagta
Beiträge: 2378
Registriert: Mo Jan 24, 2011 2:24 pm
Kontaktdaten:

Re: Pickup signal problems,

Beitrag von Alfagta »

Hello,


which type of ms do you have? (board version)

Best Regards
Wer aufhört besser zu werden hat aufgehört gut zu sein
Alfa 156 GTA
Alfa 75 Race Car MS III
Alfa 164 V6 Turbo
Test MS II
Tunerstudio V3.0.60.61 Registered
MLog View V4.3.30 Registered
MLog View HD V4.3.30 Registered
KCPpieter
Beiträge: 17
Registriert: Do Aug 27, 2015 8:55 am

Re: Pickup signal problems,

Beitrag von KCPpieter »

Alfagta hat geschrieben:Hello,
which type of ms do you have? (board version)
Best Regards

Hi, its a KDFI basic board latest version.

but changed it out with other ecu's and same faults. but i you look at the signal, after the missing thoot, its going up, and doesnt go through the 0 volt line.
Benutzeravatar
Alfagta
Beiträge: 2378
Registriert: Mo Jan 24, 2011 2:24 pm
Kontaktdaten:

Re: Pickup signal problems,

Beitrag von Alfagta »

KDFi 1,4?

Have you tried to do a trigger log within tunerstudio?
Wer aufhört besser zu werden hat aufgehört gut zu sein
Alfa 156 GTA
Alfa 75 Race Car MS III
Alfa 164 V6 Turbo
Test MS II
Tunerstudio V3.0.60.61 Registered
MLog View V4.3.30 Registered
MLog View HD V4.3.30 Registered
KCPpieter
Beiträge: 17
Registriert: Do Aug 27, 2015 8:55 am

Re: Pickup signal problems,

Beitrag von KCPpieter »

Hi,

yes, and it gives the red bars when it loses sync.

can't make more of it. but the trigger signal is to low in amplitude when i compare with all the other cars here.
and the first tooth after the missing tooth is a problem i think. but wanted to get somebody else is look on this .
Benutzeravatar
Alfagta
Beiträge: 2378
Registriert: Mo Jan 24, 2011 2:24 pm
Kontaktdaten:

Re: Pickup signal problems,

Beitrag von Alfagta »

Whart is the gap between the sensor and the toothed wheel?
Wer aufhört besser zu werden hat aufgehört gut zu sein
Alfa 156 GTA
Alfa 75 Race Car MS III
Alfa 164 V6 Turbo
Test MS II
Tunerstudio V3.0.60.61 Registered
MLog View V4.3.30 Registered
MLog View HD V4.3.30 Registered
KCPpieter
Beiträge: 17
Registriert: Do Aug 27, 2015 8:55 am

Re: Pickup signal problems,

Beitrag von KCPpieter »

Hi,

no idea original saab, so shouldn't be that much. 0.4-0.6mm i think. would need to take oil sump off to measure.
Benutzeravatar
Alfagta
Beiträge: 2378
Registriert: Mo Jan 24, 2011 2:24 pm
Kontaktdaten:

Re: Pickup signal problems,

Beitrag von Alfagta »

The pattern from the wheel looks not to bad.
VR+ and VR- are connected to the KDFI?

And please post you actula msg
Wer aufhört besser zu werden hat aufgehört gut zu sein
Alfa 156 GTA
Alfa 75 Race Car MS III
Alfa 164 V6 Turbo
Test MS II
Tunerstudio V3.0.60.61 Registered
MLog View V4.3.30 Registered
MLog View HD V4.3.30 Registered
KCPpieter
Beiträge: 17
Registriert: Do Aug 27, 2015 8:55 am

Re: Pickup signal problems,

Beitrag von KCPpieter »

Hi,

i fixed the problem with putting the sensor closser (had to machine it to be able to do that.)
the first theet after the missing 2, is not on the same dept.
Antworten