KDFI 1.4 Lambda problem
Verfasst: Mo Okt 29, 2018 11:16 am
Hello!
Sorry i don't speak German. I could find anythink online about my problem.
I have a problem with my lambda controller.
Setup:
- KDFI 1.4 Basic 3.4.2 firmware;
- new wideband 0258007351 tested on Innovate LC1 in another car, it works;
- wiring ok;
- GP2 connected to ground;
- WB out connected to OXY;
- engine starts, all sensors are reading ok.
The problem:
Lambda stays at 14.7-14.9 most of time, and sometimes goes to 18-19 and stays there until i restart the engine.
The green led flashes quick for about 30 seconds after startup, then flashes slowly until i stop the engine. On ocasion the red led flashes once briefly.
I tried to richen up the mixture to see if it reads a rich condition and it never does.
Sorry i don't speak German. I could find anythink online about my problem.
I have a problem with my lambda controller.
Setup:
- KDFI 1.4 Basic 3.4.2 firmware;
- new wideband 0258007351 tested on Innovate LC1 in another car, it works;
- wiring ok;
- GP2 connected to ground;
- WB out connected to OXY;
- engine starts, all sensors are reading ok.
The problem:
Lambda stays at 14.7-14.9 most of time, and sometimes goes to 18-19 and stays there until i restart the engine.
The green led flashes quick for about 30 seconds after startup, then flashes slowly until i stop the engine. On ocasion the red led flashes once briefly.
I tried to richen up the mixture to see if it reads a rich condition and it never does.